I am trying to read and later change the firmware in a FS-THX9X.
I have installed:
The SP Basic Rev 1.1 9X Programmer and the driver for Windows (I'm using Win7).
eePskye
When I try to Read Firmware from TX, I get the error message:
"Tx Disk Not Mounted"
Where do I go from here?
TNX
A little help getting started please
-
- Posts: 1
- Joined: Wed Oct 28, 2020 6:36 pm
- Country: -
- MikeB
- 9x Developer
- Posts: 17995
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: A little help getting started please
You need to use eepe, not eepskye.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: A little help getting started please
Find er9x manual here: http://openrcforums.com/forum/viewtopic.php?f=5&t=6473
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).