I am completely new to transmitter mods and i flashed my FLYSKY TH9x that came with flysky FS-RM003 AHFDS2A Module.
I have recently upgraded my firmware from stock flysky firmware to eR9x firmware and later realised that my FSia10B receiver binds with the transmitter but servos do not move at all
the protocol set was:
Proto PPM 10CH 300uS
PPM FrLen 26.5mSec
Polarity POS
Is there any er9x firmware version that supports this stock AHFDS2A protocol modules ?
if not where do i find the original flysky firmware so that i can revert back to my factory firmware and settings?
Please help,
thanks.
9X with RM-003 module
Re: Er9x test versions
Replace the module with a multi protocol JP4IN1 and everything will be fine.
- MikeB
- 9x Developer
- Posts: 17994
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Er9x test versions
Try polarity NEG.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
-
- Posts: 3
- Joined: Wed Sep 09, 2020 4:17 am
- Country: -
-
- Posts: 3
- Joined: Wed Sep 09, 2020 4:17 am
- Country: -
Re: Er9x test versions
Dear mike,
I have a ER9x firmware with flysky FS-RM003 AHFDS2A Module and FS-IA10B AHFDS 2A Receiver
Is it possible to get telemetry data like battery voltage, gps cordinates, Altitude etc using
I2C sensors connected to an arduino nano that can be connected to the I-BUS telemetry port on the FS-IA10B receiver
is this even possible if so how do i go about it ?
also forgive me if this is the wrong place to post this topic.
Thank you
I have a ER9x firmware with flysky FS-RM003 AHFDS2A Module and FS-IA10B AHFDS 2A Receiver
Is it possible to get telemetry data like battery voltage, gps cordinates, Altitude etc using
I2C sensors connected to an arduino nano that can be connected to the I-BUS telemetry port on the FS-IA10B receiver
is this even possible if so how do i go about it ?
also forgive me if this is the wrong place to post this topic.
Thank you
Re: Er9x test versions
No, that module doesn't supply telemetry.