Page 1 of 1
Replace RS with momentary switch Taranis X9D?
Posted: Sun Jun 21, 2020 8:36 pm
by pmullen503
Is it possible to swap a momentary switch for RS? I'd like an additional momentary switch, not just moving SH.
Re: Replace RS with momentary switch Taranis X9D?
Posted: Mon Jun 22, 2020 6:52 pm
by thebriars0
I replaced one of the three position switches with a second momentary switch. Quite easy, a bit of soldering, and reconfigure OpenTX to recognise the new momentary. Would this help?
Re: Replace RS with momentary switch Taranis X9D?
Posted: Tue Jun 23, 2020 12:14 am
by pmullen503
I suspect that replacing a pot would require matching resistance at either end of the travel. I was hoping someone had done it and knew for sure.
Re: Replace RS with momentary switch Taranis X9D?
Posted: Tue Jun 23, 2020 6:35 am
by Kilrah
Resistance at end of travel is 0...