Failsafe kinda of works
Posted: Wed Jan 29, 2020 1:05 pm
Re: Failsafe test
Post Tue Jan 28, 2020 1:41 pm
I'm looking for some help with binding Two receivers to one IMAC plane. I'm using a RX8BR receiver to a redundancy BUS-10 for 8channels using two batteries for redundancy. Am also using a XM+ receiver as a redundancy back up for the receiver. First question...when binding these receivers do I need to change receiver number for each one while binding example, bind 2 then bind 3 ? I'm using a X12s open transmitter. I'm also plugging the receivers into the bus-10 RX1 in and (RX2 in (MX+))
Second question...the fail safe mode seams to work .. but I'm getting an over travel situation on my throttle servo that I'm testing fail safe with. It does go to the low throttle position but it's going past throttle stick position. Can any one help?
heliperry
Post Tue Jan 28, 2020 1:41 pm
I'm looking for some help with binding Two receivers to one IMAC plane. I'm using a RX8BR receiver to a redundancy BUS-10 for 8channels using two batteries for redundancy. Am also using a XM+ receiver as a redundancy back up for the receiver. First question...when binding these receivers do I need to change receiver number for each one while binding example, bind 2 then bind 3 ? I'm using a X12s open transmitter. I'm also plugging the receivers into the bus-10 RX1 in and (RX2 in (MX+))
Second question...the fail safe mode seams to work .. but I'm getting an over travel situation on my throttle servo that I'm testing fail safe with. It does go to the low throttle position but it's going past throttle stick position. Can any one help?
heliperry