setting up for devo receiver on QX7s
Posted: Thu Jul 25, 2019 6:31 am
Hi,
I am using Walkera Devo receivers. the problem that I am having is that I cannot get channel one on the transmitter to output to channel one on the receiver. No matter what I do, TX1 goes to RX2, and vice versa. The input and mixer pages both show Ch1 as Ele, and Ch 2 as Ail.When I move the sticks for channel 1 elevator (I use mode 2), the correct output shows on the transmitter, but that output goes to channel 2 on the RX, which, on the Walkera RX's, is Ail.. This makes it extremely difficult to set up wings, because I always put channel one on the right aileron, and channel 2 on the left. I am having problems setting the wing up. I have done it before, but can't recall how. I know I had problems though.
Can someone tell me how to get channel one on the transmitter to go to channel one on the receiver please.
Dave./
I am using Walkera Devo receivers. the problem that I am having is that I cannot get channel one on the transmitter to output to channel one on the receiver. No matter what I do, TX1 goes to RX2, and vice versa. The input and mixer pages both show Ch1 as Ele, and Ch 2 as Ail.When I move the sticks for channel 1 elevator (I use mode 2), the correct output shows on the transmitter, but that output goes to channel 2 on the RX, which, on the Walkera RX's, is Ail.. This makes it extremely difficult to set up wings, because I always put channel one on the right aileron, and channel 2 on the left. I am having problems setting the wing up. I have done it before, but can't recall how. I know I had problems though.
Can someone tell me how to get channel one on the transmitter to go to channel one on the receiver please.
Dave./