openrcforums

The Trim button is not working very well......assuming all trim is at the center......to center all the trim, I just press the trim button u til I feel the vibrate.

Now, if I press the Right trim button once, then press the left trim button once its should go back to center and feel it vibrate, this will work only up to 3 click only.

If you press right click 4 times your should able to put it back to center by pressing 4 times left trim button......but it only need 3 time then you feel it vibrate........

If you press right click 10 times .......you need only 8 times to put it back to center.......

I am not sure if this is a bugs or need to set some setting in the transmitter......

You have the trim increment set to "EXP" (Exponential).
Try going to "Model Setup / General", scroll down to "Trim Inc" and set it to "Fine"

João

Ok......Now its working Perfectly......Thanks again.

See a fast result here......