openrcforums

I want to use two FLVSS battery sensors on one airplane.

No I understand that I need to change the sensor ID on one of them.

According to the FrSky website this can be done with their FUC-3 in combination with the small diode board.

I have downloaded the S.Port Tool also from FrSky website. This comes with a manual also showing the procedure with an FUC-3 but when I start the program it does not recognise the FUC-3. There is a Pull Down Menu next to connect. There you should select the COM port.
It does not show any COM port in the list to select. I have reinstalled the drivers for the FUC-3 and it does show up in my device manager as COM3

I have also tried on three different laptops with variations of Windows versions without a positive result.

Does any body have a clue what I am doing wrong?

You will need the FUC-3 plugged in and showing in device manager before you run the SPort tool.

Mike

I jave the FUC-3 plugged in and visible in device manager before starting up S.port tool but no change. Still invisible.

What is the name and date on the SPort tool file? Mine is FrSky_SPORT_tool_20140221.exe dated 21/02/2014 13:20.

Mike

I have the same date. 2014-02-21

Try typing com3 into the box, then click connect.

Mike

I can not type in the box

Sorry you where right. It works

So simple. Now to get my sensors back from my friend so I can change sensor ID

Thanks Mike