My target is to put the rotary encoder inplace of the P3 pot.
What do I do with the remaining three wires of the obsolete P3? Just leave them apart or connect them together ?
regards
manu
How do I take P3 out of service
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
How do I take P3 out of service
Why don't you do what I have done.
Put the encoder where the trainer switch normally sits.
Then put a small spring loaded push button on the back of the tx to replace the trainer switch
End result... Gain an encoder... Don't loose anything
Sent from my iPhone using Tapatalk
Put the encoder where the trainer switch normally sits.
Then put a small spring loaded push button on the back of the tx to replace the trainer switch
End result... Gain an encoder... Don't loose anything
Sent from my iPhone using Tapatalk
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
How do I take P3 out of service
Good idea Rob.
I probably try this option on the left hand side as I already swapped the momentary switch to the left/THR CUT. (For me as a righthander this triggers the launch phase for a DLG Model ).
I probably try this option on the left hand side as I already swapped the momentary switch to the left/THR CUT. (For me as a righthander this triggers the launch phase for a DLG Model ).
Re: How do I take P3 out of service
If you do remove the pot , do NOT short the wires together .
Tape up the bare ends of each lead.
-Brent
Tape up the bare ends of each lead.
-Brent
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: How do I take P3 out of service
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!