Retract servo programming
Posted: Wed Sep 19, 2018 5:14 am
I have a retract servo that I am trying to set up to swing the canard on a Beech Starship.
As a retract servo, the arm rotates 180 degrees but as a wing swinger, I want only 90 degrees.
Is it possible to configure this in ErSky9x?
(I have tried many combinations of full/half, limits etc without success.)
Cheers and thanks,
Stephen
As a retract servo, the arm rotates 180 degrees but as a wing swinger, I want only 90 degrees.
Is it possible to configure this in ErSky9x?
(I have tried many combinations of full/half, limits etc without success.)
Cheers and thanks,
Stephen