Throttle is inexact

[MojoMaestro]

When i start my Tx and check my analog inputs my throttle show +100 when it's all the way up, ZERO when i'm at middle stick & when all the way down it shows -75.4 instead of -100. ?


So i have to put the Throttle trim all the way down (has #.1 on pic) to set it at -100 like normal.
Don't have a choice to do that or the ESC of my models give me the continuous
beep beep ...... to notify that the throttle is not at ZERO.

Why & How to...

[jhsa]

try calibrating the sticks.. maybe that´s your problem.. don't forget to put all the trims in the middle before

[MikeB]

Sounds like you have T-TRIM turned ON in the model setup menu. That's what happens when it is turned on. It's foir IC engines where the trim is used to set the idle, and the trim does not affect full throttle. You can also then use the trim to cut the engine, or a switch if you want to.

Mike.

[MojoMaestro]

Exact my T-TRIM was ON, now it's OFF & the problem disappeared.
Thank You Mike & jhsa.

[jhsa]

Good that you've sort it out.