Maybe someone can help me...
I tried to Mod my 9XR for FrSky Telemetry. I bought a nice USB-ISP Programmer and crimped a 10->6 Pin cable. Flashing is no Problem. er9x works great.
The problem was the hardware part. I bought some tiny flexible wire. But maybe my soldering iron is not that good. So after x tries to solder the two wires to the two ports 41/42 i abrupted pin 42 of the Chip.
Is there any possibility to repair that pin? I've read something about using a dremel to expose a bit of the pin, to solder the wire again.
Or should i better buy a new Main Board? Its not very expensive with 7-8$ - But shipment from Hong Kong to Germany is VEEERY slow. (And i want to fly...)
Another question: Should telemetry work, even when Pin 41/42 not connected correctly? I connected ATmega Pin 2 to Pin 5 of Modul-Header and modified FrSky DJT, too, like in the HowTo. But no Telemetry. Maybe the connection in the DJT isn't great, too. - I will buy a new soldering iron. Before doing anything again...
I am an idiot, i know it... Big fail
![Sad :(](./images/smilies/icon_e_sad.gif)
Regards
Skyscraper