range check
range check
anyone know how to set up a servo to continuously move so I can range check?
Re: range check
Go to templates. You have a servo tester there.
Or, my favorite and easier in my opinion, go to custom switches:
S1 TimeOff 6 On 6 RUD
Now in the mixer pick up a channel
CH8 100% FULL switch (S1) slow (up 4 : down 4)
Activate the rudder switch and CH8 will go from -100 to 100 in 4 seconds, wait 2 seconds, and back to -100 again. Make sure the servo is not reaching its mechanical limits or it could be damaged. If so reduce the channel limits in the limits menu.
João
Or, my favorite and easier in my opinion, go to custom switches:
S1 TimeOff 6 On 6 RUD
Now in the mixer pick up a channel
CH8 100% FULL switch (S1) slow (up 4 : down 4)
Activate the rudder switch and CH8 will go from -100 to 100 in 4 seconds, wait 2 seconds, and back to -100 again. Make sure the servo is not reaching its mechanical limits or it could be damaged. If so reduce the channel limits in the limits menu.
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW