Hi
I hope somebody can help.
Current State: Turn on and opentx 2.0.7 is loading fine. I have also access to the SD Card. So good.
But i can't manage to get into boadlader mode. No way (screen blank). I have also tried to flash original firmware (it says something like bootloader not recoginezed) (in DFU-Mode). Also opentx firmware no way. It seems that the boatloader is corrupt....
Andy help
Thank's
This time really bricked Taranis
Re: This time really bricked Taranis
o.k.
i have found this.
http://open-txu.org/home/undergraduate- ... t-loaders/
my last solution. i will try that
Thank's
Andy
i have found this.
http://open-txu.org/home/undergraduate- ... t-loaders/
my last solution. i will try that
Thank's
Andy
Re: This time really bricked Taranis
Andy. There are TWO bootloaders!Morphin wrote:It seems that the boatloader is corrupt....
Take a deep breath and start reading. -> opentx university.
AND DON'T MISS THAT PAGE!! http://open-txu.org/home/special-intere ... d-taranis/
And you might put your Taranis away for a while. It is not a good idea to do things in a hectic
![Wink ;)](./images/smilies/icon_e_wink.gif)
If the "firmware" bootloader won't work, there is always the other "hardware" bootloader.
Good luck - KH
Last edited by kalle123 on Sun Jan 11, 2015 7:08 pm, edited 1 time in total.
Re: This time really bricked Taranis
Hy Andy,
take the German Manual for openTx and Taranis here, its from 14.12. 2014
http://fpv-community.de/showthread.php? ... 1-99/page6
Downloads at #57 and #58
you will find what you need for update Firmware and Bootloader
Helle
take the German Manual for openTx and Taranis here, its from 14.12. 2014
http://fpv-community.de/showthread.php? ... 1-99/page6
Downloads at #57 and #58
you will find what you need for update Firmware and Bootloader
Helle