N2 Industries Airspeed indicator
-
- Posts: 32
- Joined: Wed Jul 17, 2013 9:00 am
- Country: -
N2 Industries Airspeed indicator
I have purchased and installed an N2 industries airspeed indicator but cannot get any readings from it. I have setup the telemetry as I beleive it should be, but would be greatful if somebody could have a look for me just to make sure. am attaching the model eep. Thanks in anticipation.
- Attachments
-
- Bocean.eepe
- (77.03 KiB) Downloaded 329 times
-
- Posts: 32
- Joined: Wed Jul 17, 2013 9:00 am
- Country: -
Re: N2 Industries Airspeed indicator
No body interested in this then!!
-
- Posts: 10
- Joined: Mon Dec 09, 2013 6:47 pm
- Country: United Kingdom
Re: N2 Industries Airspeed indicator
Hi Cliff, I have one of these and set it up exactly as per the instructions, it worked as it should. Unfortunately I have been unable to compare your settings to mine as I have had problems downloading settings into Companion so I have not done a back up for a while.
I take it you have double checked everything right down to making sure you are plugged into the Smart Port, I only say this as I couldn't get a vario to work and that was the reason.
Andrew
I take it you have double checked everything right down to making sure you are plugged into the Smart Port, I only say this as I couldn't get a vario to work and that was the reason.
Andrew
-
- Posts: 32
- Joined: Wed Jul 17, 2013 9:00 am
- Country: -
Re: N2 Industries Airspeed indicator
Thanks for your reply, yes everything checked, perhaps you could send youyr setting for me to compare this end.
Cliff
Cliff
-
- Posts: 10
- Joined: Mon Dec 09, 2013 6:47 pm
- Country: United Kingdom
Re: N2 Industries Airspeed indicator
Hopefully the attachment will work. The ASI is in my Taylorcraft and is the last sensor in the chain with a Vario and GPS sensor.
- Attachments
-
- Taylorcraft.eepe
- (76.03 KiB) Downloaded 192 times
-
- Posts: 32
- Joined: Wed Jul 17, 2013 9:00 am
- Country: -
Re: N2 Industries Airspeed indicator
Thanks you. Will try later.