N2 Industries Airspeed indicator

[CliffEvans]

I have purchased and installed an N2 industries airspeed indicator but cannot get any readings from it. I have setup the telemetry as I beleive it should be, but would be greatful if somebody could have a look for me just to make sure. am attaching the model eep. Thanks in anticipation.

[CliffEvans]

No body interested in this then!!

[andrewfl290]

Hi Cliff, I have one of these and set it up exactly as per the instructions, it worked as it should. Unfortunately I have been unable to compare your settings to mine as I have had problems downloading settings into Companion so I have not done a back up for a while.

I take it you have double checked everything right down to making sure you are plugged into the Smart Port, I only say this as I couldn't get a vario to work and that was the reason.

Andrew

[CliffEvans]

Thanks for your reply, yes everything checked, perhaps you could send youyr setting for me to compare this end.

Cliff

[andrewfl290]

Hopefully the attachment will work. The ASI is in my Taylorcraft and is the last sensor in the chain with a Vario and GPS sensor.

[CliffEvans]

Thanks you. Will try later.