This is a Blade 130X template for a Taranis TX.
This is based on the HeliFreak OpenTX forum template model. (http://www.helifreak.com/showthread.php?t=598718) It has:
- 9 flight modes (switched by SE and SC
- DR&expo for 3 positions (SG)
- Throttle hold on SF or but toggling SH (momentary)
- Manual default pitch and throttle curves for Normal, UI1, UI2 and Hold
The switch positions are based on the DX8 (and DX6i and RF interlink controller).
Designed for use with the OrangeTX DSMX module (you may need to tweak the Module 2 settings).
Can do most of the other Blade BNF heli's if people want (nano CPX, mCPX, mCPX BL, 300X, 450X, 4503D (both beginner and adv), 500X, 5003D, mSRX, mSR, SR120).
Will upload a Turnigy 9xr version soon. (5 flight modes).
Enjoy and tell me what you think.
Blade130X template
-
- Posts: 2
- Joined: Sat Feb 08, 2014 2:01 pm
- Country: -
Blade130X template
- Attachments
-
- Blade130Xs.eepe
- (77.03 KiB) Downloaded 1043 times
-
- Posts: 11
- Joined: Fri Feb 14, 2014 11:54 am
- Country: -
Re: Blade130X template
I just ordered a Blade 450x. An eepe for this would be fab. Thanks Bro.
Steve
Steve
Re: Blade130X template
Not quite sure why I can not open your eepe file. eepe (rev 392) sees it as "hex" and wont open it. What am I doing wrong?
- MikeB
- 9x Developer
- Posts: 17994
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Blade130X template
I think it is a eepe file for openTx on the Taranis, not for eepe.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Blade130X template
Thankyou
Re: Blade130X template
Thanks ArchmageAU for posting this. My Blade 130X flew many times when I had a Spektrum transmitter. However I'm a relative beginner at Taranis and can't get this EEPROM to work for me. I've transferred it onto my Taranis OK (ver 2.0.13) which has an Orange DSM2/DSMX module fitted. The cyclic, tail and collective controls work fine. However I can't get the motor to start, and the object of all the flight modes is lost on me. Previously following the heli setup instructions I had a simple "throttle increasing increases motor power and collective" setting and an aerobatic setting "constant motor power and throttle stick operates collective only" on my Spektrum, and it's all I really need.
Can you give me beginner-level instructions on how to use your program?
I know I need to set the internal RF to off and the External RF to PPM. Please can you tell me if my settings
"Channel range CH1-8
PPM frame 22.5 ms 300u -"
are correct?
Many thanks
Stuart
Can you give me beginner-level instructions on how to use your program?
I know I need to set the internal RF to off and the External RF to PPM. Please can you tell me if my settings
"Channel range CH1-8
PPM frame 22.5 ms 300u -"
are correct?
Many thanks
Stuart