FatShark Head Tracker

[WZ9V]

Could someone point me to what I'd need to do to use the trainer port for feeding the two FatShark head tracker outputs through as inputs sent to the RX?

I found someing on ER9X that says configure an input mix for PPM(X) where X = the desired Head Tracker channel.

[Kilrah]

Same on the Taranis if you're on the stock firmware.

[WZ9V]

I'm on 2.0.8, does that make a difference?

[Kilrah]

None apart from the fact that the sources are called TRxx instead of PPMx.

[WZ9V]

Thanks. I'll check it out.