How to transfer models from er9x

[ajghor]

Hi,

I have a problem transfering my models from my old Turnigy 9x with er9x on it to 9xr PRO.
Opening the .eepe file in eepSKYe doesn't do anything, and when I try to copy the moedl from eepe, it says it isn't supported.
Even saving my models one by one, and loading them in 9xr pro, resulted only in the name been transfered nothing else.

Is there a way to do it?

[jhsa]

try opening eepe and eepskye at the same time.. just drag models from eepe to eepskye. ignore the error.. CHECK EVERYTHING WORKS as there might be differences..

I just tried it and worked for me..

João

EDIT: Yeah there are some differences but most of it is correct
ATENTION: Elevator and Trottle could be swapped.. Don't turn the model on before checking all channels are where they should..

[ajghor]

João,

You are right, that actually worked.
I could swear that I have tried it without success , must be growing old

Many thanks!

[ajghor]

Just found out that there is a post by Mike about transferring models in Transmitter Hardware/9xr PRO.

Should have done my homework better before asking...

[jhsa]

No problem. Double of the chances new people find it now

João