Possible bug with failsafe settings

[seancull]

Hi, I got my Taranis this week and I am really loving all that the community has done with it and the companion software - the compaion software makes everything so much better including the learning curve.

I noticed that when I manually set a custom failsafe on the transmitter the rudder value ( channel 4 ) shows correctly in the Companion "screen simulator" i'e the bit that looks like Taranis but in the failsafe tab of the model editing section the values are different - see attached screenshot.

When the eprom is reflashed from companion it uses the correct value , in this case -24.5

Is this a bug ? Where should I raise bugs ?

Thanks, Sean
version 1.52 build 2381 with firmware EEPR 215 / opentx-r2940

[Kilrah]

Yes, there is an (already solved for next version) bug in companion.