![Image](http://www.file.emiter.hu/file/Modellezes/GCL2/GCL-2%20013_logo2.jpg)
More info: http://www.rc-miskolc.emiter.hu/rc-misk ... Itemid=179
Put separate channel on receiver:
![Image](http://www.file.emiter.hu/file/Modellezes/GCL2/abra3.jpg)
(Free receiver channel connected)
![Image](http://www.file.emiter.hu/file/Modellezes/GCL2/Abra6.jpg)
This time you need to program the right glowing upper and lower threshold on radio. Then enough put the threshold somewhere near the middle on GCL-2. The mixes, which on this channel of radio, will supply the right glowing functions (on/off, engine stop).
Sample glowing program under ER9X (for Turnigy 9X TX):
Implemented functions:
The throttle servo is placed on 3.ch, the glow is placed on 7 ch.n,
Main switch of glowing (disable/enable) : GEAR switch,
Motor cut switch: TRN switch.
The glowing is active, if the GEAR switch on and the throttle is on idling speed (The upper section of glowing is adjusted with GCL-2 „pos” trimmer.)
The glowing is OFF, when the motor cut is in use (for more successful stoping)
Mixes:
motor cut:
CH3 R -125 FULL TRN
Glowing:
CH7 100 CH3 GEA
R 100 FULL !GEA
SAFETY SWITCHES:
CH7 S TRN 100