Ok check this picture and link to be sure you have a v2 board
http://www.smartieparts.com/shop/index. ... =page&id=8
Next check to see that your programmer driver is loaded and your computer sees it and its port #.
I'm not familiar with the latest sp board but all my older versions work well with eepe so I know it works.
In the past the USB connector sites could break off but I'm sure not anymore. I also think the radio power must be on now. Maybe not from your beeping comment.
Tell more about the beeping?
If the USB SP connection is providing the tx 5 volts and the firmware is still stock, the beeping is normal. The 9x thinks the tx battery is too low. That goes away with new FW.
Sorry to be redundant but if these tips fail you may have a defective SP board and Steve needs to look at it.
Don't give up, you've just hit a rough spot.
SM
Sent from my iPod touch using Tapatalk.
Please add a location to your profile. Thank You