So Today I found the first reason I wish I had not converted a transmitter to sky9x board. Because I have to change the parameters in the Configure menu for Samaba etc. Then when I want to use a different transmitter that does not have sky9x so will not work with samba -- I have to change the configuration again -- if i can remember what the other configuration was.
It sure would be handy if Companion9x could save different connection configurations or even recognize which board just hooked up and automatically change to a saved configuration.
One program - Two transmitters
-
Scott Page
- Posts: 864
- Joined: Wed Dec 28, 2011 3:32 am
- Country: United States
- Location: Tri-Cities, Washington State
-
Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: One program - Two transmitters
Lol... it does!
Check the preferences. You can setup different profiles.. then choose FILE->PROFILE XX
Rob
Check the preferences. You can setup different profiles.. then choose FILE->PROFILE XX
Rob
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: One program - Two transmitters
Look at the Firmware profiles feature 
-
Scott Page
- Posts: 864
- Joined: Wed Dec 28, 2011 3:32 am
- Country: United States
- Location: Tri-Cities, Washington State
Re: One program - Two transmitters
DUH! (gawd am I an idiot!)
-
Romolo
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: One program - Two transmitters
No you are not an idiot, I only had your same problem before with stock , gruvin, sky9x board so i had to solve.
There is also a button in the toolbar to fast change the active profile.
Furthermore in the profile you can save also radio calibration and patch eeproms on the fly using the stored values.
There is also a button in the toolbar to fast change the active profile.
Furthermore in the profile you can save also radio calibration and patch eeproms on the fly using the stored values.