Dear guys,
anybody succesfully tried to mount FUTABA DM8 Module into ER9X? After success with MLP4dsm, i want to try this full range module...
It seems very easily, but I am not sure, if 3 wires (+, - , signal) is enough to run it...
Thanks for your answer!
Ondrej
Futaba DM8 module with ER9X
- Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Futaba DM8 module with ER9X
Yes. That should work. Only issue is securing the box effectively!
Sent from my Nexus 7 using Tapatalk 2
Sent from my Nexus 7 using Tapatalk 2
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
- cre8tiveleo
- Posts: 1434
- Joined: Tue Dec 27, 2011 6:13 pm
- Country: -
- Location: Ontario,(GTA North)
- Contact:
Re: Futaba DM8 module with ER9X
WOW!! this board seems perfect! Dont you know, if there is only Voltage stabiliser or other parts? Thanks!
Re: Futaba DM8 module with ER9X
Seems perfect! but ---out of stock:( and no more sources of this product on market:(
Re: Futaba DM8 module with ER9X
In stooock! Hooorray!!
Re: Futaba DM8 module with ER9X
If to invert the 10th pin of the dm8 futaba microcontroller turns into dm9 JR!!! polarity of input PPM and an arrangement of channels changes. If the stok firmware - is better to use as dm8, then the sequence of channels is true and BNF work truly. if er9x, it is better to change contact and there will be 9 channels. Pin10 connect or not connect to GND.