c9x v1.03 r 1512 crashes while burning flash into sky9x

[manu]

Now I'm in trouble.
This morning I updated c9x to to the latest release.
At the 1st attempt to burn a new fw into sky9x, c9x crashes. The new fw is loaded but the model memory/eeprom is reformatted.
I tried to load a old eepe file from the pc, tried to restore a model from the sd card. Both fails with "invalid" format.
Did I loose all my model settings?
regards
manu

[bertrand35]

Would you try the 1.04? I just fixed a bug there (for sky9x / gruvin9x / M128 boards).
Bertrand.

[manu]

My main problem is:
Is there a way to restore my model settings of a former fw release?

[Kilrah]

Yes, you should be able to open any previous bin/eepe file and then write it (not write from file, as eeprom format might have changed inbetween). BTW, ALWAYS do a manual backup before flashing. I also make one everytime I do some major changes to my model settings just in case.

BTW, for me 1.04 still fails on backup/restore with my m128 radio. If I load a correct eeprom on the radio, then reflash the same firmware with backup/restore enabled, c9x doesn't crash anymore but the radio says invalid eeprom. It's OK on stock board.

[manu]

I are right. Just that particular on I thought was my latest backup is corrupted, bad luck. Earlier ones are ok to load.

[bertrand35]

1.05 now released. The problem should be fixed.
One stupid thing is that this last open9x version / sky9x board already does the conversions internally, if you didn't have checked the "backup" checkbox, there would not have been any problem (hmm. correct english?)
Bertrand.

[manu]

c9x v1.05 still crashes when flashing eeprom with fw compatibility checked.

[manu]

Telemetry A1 channel settings are zeroed when flashing eeprom into sky9x.