hello guys i installed my gruvin9x board and so far it works fine but when i tried to use the Gprog i get this message
avrdude.exe: Device signature = 0x1e9801
avrdude.exe: Expected signature for ATMEGA64 is 1E 96 02
Double check chip, or use -F to override this check.
avrdude.exe done. Thank you.
the green led is on and in my devices i see usbasp device, but it's not communicating with the computer.
i need help
unable to use Gprog on Gruvin9x board
-
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: unable to use Gprog on Gruvin9x board
you need to select a open9x for gruvinv4 under preferences in companion.
Re: unable to use Gprog on Gruvin9x board
Thanks, i did what you said and it worked. once
i read the flash memory, after that i got the following message when i tried to write firmware to TX
Started AVRDUDE
C:/Program Files (x86)/companion9x/avrdude.exe -c usbasp -p m2560 -P usb -U eeprom:r:C:/Users/Adri/AppData/Local/Temp/temp.hex:i
=================================================================================
avrdude.exe: error: programm enable: target doesn't answer. 1
avrdude.exe: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude.exe done. Thank you.
=================================================================================
AVRDUDE done - exit code 1
=================================================================================
what do i do now?
i read the flash memory, after that i got the following message when i tried to write firmware to TX
Started AVRDUDE
C:/Program Files (x86)/companion9x/avrdude.exe -c usbasp -p m2560 -P usb -U eeprom:r:C:/Users/Adri/AppData/Local/Temp/temp.hex:i
=================================================================================
avrdude.exe: error: programm enable: target doesn't answer. 1
avrdude.exe: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude.exe done. Thank you.
=================================================================================
AVRDUDE done - exit code 1
=================================================================================
what do i do now?
Re: unable to use Gprog on Gruvin9x board
latest news on my issue is as follows:
i plugged the 6 pin connector from a sparkfun attiny board that i used to mod
another 9x and it works flawlessly, maybe the Gprog itself has a problem.
time to send it back for a replacement?
i plugged the 6 pin connector from a sparkfun attiny board that i used to mod
another 9x and it works flawlessly, maybe the Gprog itself has a problem.
time to send it back for a replacement?
-
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: unable to use Gprog on Gruvin9x board
Have a look to soldering it's very strange...
It answer (it's recognized as an usbasp) so it's unlike that's broken.
It answer (it's recognized as an usbasp) so it's unlike that's broken.