I set up one of my 9x transmitters with a DM9 module and bound it to two programmed models. Everything worked as expected except that there was no trim. I tripled checked that trim was selected ON in all mixes for both models, but the trims didn't work.
After much head scratching I selected trim OFF in the mixes and , walla!, the trims now work!
Looks like something is screwy in the FW. Trims for other models programmed on this Tx using a Corona module work fine when selected ON.
This when using er9x ver 760.
Ted.
DM9 Module and Trim Issues
Re: DM9 Module and Trim Issues
I recall reading about a bug where ON/OFF were reversed indeed, was fixed in later versions of the firmware. I don't remember when that was, but you might want to upgrade.
I move this to er9x.
I move this to er9x.
Re: DM9 Module and Trim Issues
Thanx, I apparently missed any previous reference to this issue.
Ted
Ted