hi im new to the 9x and have a question , is there a way to bind my 3 nine eagles helis and my trex100 and my 9958 to the 9x as i would like to use 1 radio as i have a tone of them laying around .
apprish any help on the matter
thanks
mark
binding 9x
-
wheelspinner20
- Posts: 175
- Joined: Tue Dec 27, 2011 6:22 pm
- Country: -
- Location: Michigan, U.S.
Re: binding 9x
As you might already know. The 9958 already has a flysky based receiver board.
Go to the 9958 site http://www.rcgroups.com/forums/showthread.php?t=1536792
to see directions for binding your 9x to it. The other models, if I'm not mistaken have a different 2.4 protocol which has not been developed yet in er9x.
Its not impossible, I guess, to hack a nine eagles or align transmitter module to work with the ppm control of the the 9x, but it would require, for sure, hardware modification, and firmware also to contol the pulse generation to match those receiver protocols.
Go to the 9958 site http://www.rcgroups.com/forums/showthread.php?t=1536792
to see directions for binding your 9x to it. The other models, if I'm not mistaken have a different 2.4 protocol which has not been developed yet in er9x.
Its not impossible, I guess, to hack a nine eagles or align transmitter module to work with the ppm control of the the 9x, but it would require, for sure, hardware modification, and firmware also to contol the pulse generation to match those receiver protocols.
no more quippy little latin phrases.! Its old