Hi,
Help, I can't enter the configuration mode of my er9x turnigy.
I do the usual, trims inside and turn on the tx, but on the screen it puts me "stopped"
I was trying to save changes of my models in eePe and there is no way to remove "stopped" from the screen. I can't connect tx to pc.
Do any of you know why this happens to me?
eePe save model problem
-
MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: eePe save model problem
The original 9X running er9x doesn't use trims inwards method to allow access to the EEPROM.
You should be connecting using a USBASP (or smartieParts) programmer.
The "stopped" message is there to allow serial access to a "MegaSound", addon board.
Mike
You should be connecting using a USBASP (or smartieParts) programmer.
The "stopped" message is there to allow serial access to a "MegaSound", addon board.
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: eePe save model problem
Hello,
thanks for replying. In the end it was the data cable, the funny thing is that I tried a second cable that I use to charge the mobile that works for that reason and did not work either. Today I tried with a third cable and with this one if it works and detects the USBASP driver and I could read the memory with eePE.
thanks for replying. In the end it was the data cable, the funny thing is that I tried a second cable that I use to charge the mobile that works for that reason and did not work either. Today I tried with a third cable and with this one if it works and detects the USBASP driver and I could read the memory with eePE.