Trim change with rates

[plasticbaldy]

When I switch to a higher rate by having separate mixes with switches selecting the mix the trim drastically changes. This only occurs on the elevator servo.

[plasticbaldy]

I haven’t updated the firmware for about 4 years.

[MikeB]

A mix with a weight other than 100% will affect the trim setting.
The "best" way to handle rates is to use the "Expo/D.Rate" menu as this applies the rate setting to the stick input and doesn't affect the trim in a mix.

Mike

[plasticbaldy]

Thanks Mike,
I’ll have a go at that as soon as I get the chance to play again.