Hello,
I'm having a "trim idle only" issue on my TX16S.
If I select trim idle only, the transmitter somehow offsets the throttle mix by 50%, and throttle output runs from neutral to 100% instead of -100% to +100%.
If I deselect trim idle only, the throttle output returns to normal.
This was on a freshly created model, no mixes or offsets appear in the inputs, outputs and mixer menus.
A flying buddy of mine is having the same issue on his TX16S.
Any ideas?
Trim idle only issue
Re: Trim idle only issue
Version?
What's set as Trim Switch?
What's set as Trim Switch?
Re: Trim idle only issue
Transmitter is running otx 2.3.10
Trim switch is the stock assigned throttle trim switch T3
Trim switch is the stock assigned throttle trim switch T3
Re: Trim idle only issue
Some fixes for that were made in 2.3.11, although it should work in 2.3.10 if you don't have special things like crossed trims
Re: Trim idle only issue
Found it:
The standard channel order is set to AETR.
I set up my model as TAER, like I'm used to from my Graupner days.
This must created some sort of conflict with the trim switches in the software.
Thanks for the feedback.
The standard channel order is set to AETR.
I set up my model as TAER, like I'm used to from my Graupner days.
This must created some sort of conflict with the trim switches in the software.
Thanks for the feedback.