I have a Guanli A10 foamy that is running with 2 55mm edf's. They are brushless out runners controlled by 2 separate ESCs that connect to a single Lipo. The stock setup has the throttle wires connected to a y-harness and then to the RX. I was thinking that if I slaved an auxiliary channel to the throttle, that I could control each ESCs/Fans with its own channel. Taking this one step further, I thought it might be possible to slave both the throttle and the aux channel to the rudder to allow for a thrust differential rudder (no rudder on this plane) Not even sure where to start on this one?
Josh
2 EDF's, 2 ESC's one battery on two throttle channels!
Re: 2 EDF's, 2 ESC's one battery on two throttle channels!
Never mind, got it figured out.. ![Embarrassed :oops:](./images/smilies/icon_redface.gif)
![Embarrassed :oops:](./images/smilies/icon_redface.gif)
Re: 2 EDF's, 2 ESC's one battery on two throttle channels!
I have the same, be careful to have the same RPM since tere is no rudder to roll on the track
Re: 2 EDF's, 2 ESC's one battery on two throttle channels!
Strangely the edf's and ESC's are identical yet one motor starts spinning a half second before the other. It has a steerable nose wheel so ground control should be easier.