Code: Select all
dfu-util 0.9
Copyright 2005-2009 Weston Schmidt, Harald Welte and OpenMoko Inc.
Copyright 2010-2016 Tormod Volden and Stefan Schmidt
This program is Free Software and has ABSOLUTELY NO WARRANTY
Please report bugs to http://sourceforge.net/p/dfu-util/tickets/
/usr/bin/dfu-util -a 0 --dfuse-address 0x08000000:524288 --device 0483:df11 -U/home/jeffe/opentx/bkup
=================================================================================
dfu-util: No DFU capable USB device available
=================================================================================
On the Taranis radio, I am pretty sure I have it in the right configuration, I got into the "write firmware" menu, and it says, "USB Connected" (and also "OTX Bootloader - 2.2.2").
I don't have an SD card in it ATM. I didn't fill out the sd card path in the companion settings yet. I am seeing some errors in dmesg, and I assume that's because I don't have an sd card (and it's trying to find it in sdc):
Code: Select all
[ 1700.622003] usb 2-2: new full-speed USB device number 6 using xhci_hcd
[ 1700.771392] usb 2-2: New USB device found, idVendor=0483, idProduct=5720
[ 1700.771397] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 1700.771400] usb 2-2: Product: FrSky Taranis Bootloader
[ 1700.771402] usb 2-2: Manufacturer: FrSky
[ 1700.771405] usb 2-2: SerialNumber: 00000000001B
[ 1700.772227] usb-storage 2-2:1.0: USB Mass Storage device detected
[ 1700.773482] scsi host4: usb-storage 2-2:1.0
[ 1701.782591] scsi 4:0:0:0: Direct-Access FrSky Taranis Radio 1.00 PQ: 0 ANSI: 2
[ 1701.782906] scsi 4:0:0:1: Direct-Access FrSky Taranis Radio 1.00 PQ: 0 ANSI: 2
[ 1701.783844] sd 4:0:0:0: Attached scsi generic sg1 type 0
[ 1701.784330] sd 4:0:0:1: Attached scsi generic sg2 type 0
[ 1701.784628] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[ 1701.785222] sd 4:0:0:1: [sdc] 1100 512-byte logical blocks: (563 kB/550 KiB)
[ 1701.785363] sd 4:0:0:1: [sdc] Write Protect is off
[ 1701.785366] sd 4:0:0:1: [sdc] Mode Sense: 00 00 00 00
[ 1701.785504] sd 4:0:0:1: [sdc] Asking for cache data failed
[ 1701.785508] sd 4:0:0:1: [sdc] Assuming drive cache: write through
[ 1701.790527] sdc:
[ 1701.791329] sd 4:0:0:1: [sdc] Attached SCSI removable disk
PS, thanks a bunch for your help. I frequent the v1engineering forums to help with open source CNC machines, and I know it's a lot of fun, but thanks go a long way.