Hello there,
I just bought a Tarot 680Pro, using a ZYX-M controller and a Taranis X9D Plus, now I'm feeling totally lost about how to configure the radio to deal with the hexacopter.
I'm looking for a template for where I can start (a generic hexacopter template maybe?) Or, if somebody has a similar setup, a "final" template will be great
Template for Tarot Hexacopter
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Template for Tarot Hexacopter
You would set it up the same as a Quadcopter, much like the same as a plane would be, using your X8R receiver.
The ZYX-M controller looks a lot like the NAZA-M Lite flight controller.
Bob B.
The ZYX-M controller looks a lot like the NAZA-M Lite flight controller.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
Re: Template for Tarot Hexacopter
So, after setting up some Naza and a2..it was pretty straight forward..the big thing I noticed once I mapped the channels the elevator was reversed, stopping the motors from starting..for me..com 4, connect..program, flash..motor test, calibrate..set switches..this is so like the Naza..hope this helps anyone,,