I bought a QX7 a while ago to try out, liked it, but use my X9D for all my models.
A friend has looked at both my radios, liked the QX7 and bought one.
His model has a 3 pin port at the bottom right of the case that mine does not, what is this for?
Secondly the default model had the throttle giving haptic feed back at center position, since flashing 2.2 this has stopped and I can't figure out how to get it back. Any clues?
Thanks.
Robert
2 QX7 questions
- MikeB
- 9x Developer
- Posts: 17996
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: 2 QX7 questions
The 3-pin port is for updating SPort devices (receivers and sensors). Early QX7s had the wrong pinout so the pins were not fitted (mine is one of those).
Look for "Beep Centre".
Mike
Look for "Beep Centre".
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: 2 QX7 questions
I use beep centre on my Taranis, but for QX7, we want it to vibrate only, not beep. Beep centre does both.
Robert
Robert