Switch from dht to xjt
-
- Posts: 1
- Joined: Fri Dec 21, 2018 12:33 pm
- Country: -
Switch from dht to xjt
Hi i have a problem maybe someone can help. I have the turnigy 9X with all thw mods done. I have fhe DHT module installed and the telemetry mod. I want to install the XJT module to be able to use D16 mode. What i did is removed the DHT and also removed the telemetry mod. I installed then the XJT module. I can bind to any rx weather in D8 or D16 but i get no response on my quad. Do I need to change the firmware on the 9X. What am I doing wrong.
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Switch from dht to xjt
Did you select XJT in the protocol ?
Which used to be called (labeled) PXX protocol (PXX which is what it is).
See here for more info: (https://openrcforums.com/forum/viewtopi ... ol#p139223)
and (https://openrcforums.com/forum/viewtopi ... ol#p134435).
Which used to be called (labeled) PXX protocol (PXX which is what it is).
See here for more info: (https://openrcforums.com/forum/viewtopi ... ol#p139223)
and (https://openrcforums.com/forum/viewtopi ... ol#p134435).
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
- MikeB
- 9x Developer
- Posts: 18010
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Switch from dht to xjt
The XJT also sends telemetry as inverted serial over the bottom pin of the module connector. If your telemetry mod included a buffer/inverter on this pin, then you probably want to keep that.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!