S6R config wizard in 2.2RC10
S6R config wizard in 2.2RC10
I have this morning been trying to configure a S6R with the s6r.lua script included on the 2.2V0005 SDCard files. I am running 2.2RC10 on a Taranis+. Page 1/2 allows me to select Delta and Horiz, then page 2/2 allows me to select Enable as first field (S6R Functions), but then all the following fields show --- and it does not allow me to change any of these. Bit stumped! Any ideas?
Re: S6R config wizard in 2.2RC10
Then transmission failed in the middle of reading parameters. Make sure you're not too close to the receiver and try again.
Re: RE: Re: S6R config wizard in 2.2RC10
I have tried dozens of times with no improvement. Getting solid green light, so no disconnection.Kilrah wrote:Then transmission failed in the middle of reading parameters. Make sure you're not too close to the receiver and try again.
Incidentally, the calibration script works fine.
Re: S6R config wizard in 2.2RC10
I'm talking of telemetry packet loss, not RC.
No module in the module bay?
No module in the module bay?
Re: S6R config wizard in 2.2RC10
No, no module. I will try again tonight.
Sent from my Nexus 6P using Tapatalk
Sent from my Nexus 6P using Tapatalk
Re: S6R config wizard in 2.2RC10
Kilrah, I just tried running through the S6R_Calibrate.lua script, and keep hitting snags running this also. When a calibration takes, it flashes the yellow LED which stays on for a second then goes off, but I have not managed to complete all the calibration steps - when it fails, the yellow LED just stays on indefinitely and the x,y,z values no longer change on the lua screen. Could I possibly have a faulty S6R?
Cheers, Paul
edit - I have just ordered the stk tool to give that a go.
Cheers, Paul
edit - I have just ordered the stk tool to give that a go.
Re: S6R config wizard in 2.2RC10
After struggling for a couple hours at this, I found the biggest problem is the transmitter and receiver must be at least 6 foot from each other, period. That's further than an one person's arms can stretch. This is very difficult to do by yourself - an assistant comes in real handy for this. If the transmitter and receiver are closer than that, the signal will be compromised and the calibration or setup lua script will be corrupted and stop working. If this happens, you have to stop the script and start all over again.
Re: S6R config wizard in 2.2RC10
I have the same problem
2.2RC10 / Taranis+.
Page 1/2 allows to change the two params
page 2/2 allows to change Enable/disable
all the other fields show ---
and they can not be changed
Going away from the model does not help
Trying again and again doesn't help
2.2RC10 / Taranis+.
Page 1/2 allows to change the two params
page 2/2 allows to change Enable/disable
all the other fields show ---
and they can not be changed
Going away from the model does not help
Trying again and again doesn't help
Re: S6R config wizard in 2.2RC10
RC10 is 3 months old, a lot has changed both in the firmware and the script since. Update before anything else.
Re: S6R config wizard in 2.2RC10
Hi
Sorry, the version i stated was incorrect
The bug is happening on version RC18 build 371 from 29/4
Sorry, the version i stated was incorrect
The bug is happening on version RC18 build 371 from 29/4
Re: S6R config wizard in 2.2RC10
Then it works, I've actually used it yesterday. Make sure you do have the durrent script version on the card, reboot everything, and go far away enough.