Binding X8R to 9XR Pro with Frsky XJT Module (Both dips to off/down) in D16

[costall]

I have successful bound my X8R receiver in D8 mode but cannot workout how to rebind it to D16. If I change the mode to D16 on the TX and then try to rebind I get a solid green and red light on the RX. As soon as I switch the TX back to D8 the reciver connects and I get a solid green light on the RX.

Is there a way to factory reset the X8R?

Any thoughts how I can rebind this receiver to D16?

Many Thanks

Paul.

[bob195558]

Hi Paul,

FrSky X8R Receiver Manual

FrSky X8R Receiver Manual: (http://www.frsky-rc.com/download/index. ... pro_id=105).

Any thoughts how I can rebind this receiver to D16?
Many Thanks
Paul.

Protocol: PXX / D16 uses Bind Mode 5 procedure.
Hold down F/S Button before powering the X8R receiver.

Protocol: PXX / D8 uses Bind Mode 1 procedure.

XJT Manual: (http://www.frsky-rc.com/download/view.p ... Manual-XJT).

Bob B.

[Kilrah]

You may have a firmware region mismatch between the module and receiver depending on where and when you've bought them. EU and rest of world use different and incompatible D16 protocols.

[costall]

Thanks Bob, yes this is the procedure I have been following.

KIlrah, I think this might be it... The receiver is labelled as an EU receiver. Thank you!

Found this useful video to change the firmware on the X8R:

https://www.youtube.com/watch?v=IvXWdBpQNvk