Automatic telemetry screen on startup
Automatic telemetry screen on startup
Hi there, I wonder if it is possible to get the telemetry Screen right on powering up the transmitter?
Re: Automatic telemetry screen on startup
Nope. It's already been suggested though, not sure what the progress is. There should be an issue for it on github you might be able to check out.
Re: Automatic telemetry screen on startup
Thx for the answer
Re: Automatic telemetry screen on startup
Optional and configurable. More like the ability to select which page to see on start up and if that page is the Telemetry then which telemetry screen to use as default.rguptaca wrote:Hope it will be optional.
- bob195558
- Posts: 2377
- Joined: Sun Dec 16, 2012 7:24 pm
- Country: United States
- Location: New England, Vermont
- Contact:
Re: Automatic telemetry screen on startup
You can do it with erSky9x firmware.
Bob B.
Bob B.
Er9x on 9x radio, with Smartieparts Programmer and TelemetrEZ Board.
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).
ErSky9x on Taranis, Sky9x, 9Xtreme radios.
3D-Printing: (https://openrcforums.com/forum/viewforum.php?f=129).