Taranis 9D upgraded and lost everything?

General Help and support for the Taranis Radio.
Post Reply
gratefulfrog
Posts: 1
Joined: Mon Sep 06, 2021 2:18 pm
Country: -

Taranis 9D upgraded and lost everything?

Post by gratefulfrog »

Hi,
I recently got an X8R receiver and could not bind to it because I had only version 2.0 of opentx, I thought.

So I upgraded to 2.3.14 and now my radio has lost all the setting for all the models, even if the models are still selectable?

I am at a loss as to what to do, any one have an idea?

Thanks so much!
Bob

pmullen503
Posts: 275
Joined: Sun May 06, 2012 8:37 pm
Country: -
Location: Fond du Lac, WI

Re: Taranis 9D upgraded and lost everything?

Post by pmullen503 »

Do you have the models saved in Companion?

If you do you can open an old version of companion and a new version of companion side by side and copy each model line by line from the old into the new. Just opening your old models in new companion will result in lots of errors.

Then you can upload the models into the tx. Make sure you update all your rx's.

Or you could just flash your tx back to 2.0 and flash compatible firmware into the x8r.
rdeanchurch
Posts: 750
Joined: Tue Dec 27, 2011 11:22 pm
Country: United States
Location: Carson City, Nv

Re: Taranis 9D upgraded and lost everything?

Post by rdeanchurch »

Also see https://www.rcgroups.com/forums/showthr ... LEASE-HELP

OpenTx has problems doing model conversion upgrading models if Version goes from, Ver2.x.z to Ver2.y.z if y-x > 1. you should go from OpenTx V2.0.z to V2.1.z then to V2.2.4 then to V2.3.14 to have the best chance at models being upgraded correctly.
Dean
OldDmbThms: 1. Takeoff, 2. Crash, 3. Repair, GOTO 1

Post Reply

Return to “General help (FrSky Taranis radio)”