Sure this has been covered somewhere but I cant find it. I'm flying an aerobatic model which Yaws perfectly when full right rudder is applied, when I apply full left rudder the nose drops very slightly. How do I setup the mix so that nothing happens with right rudder but a percentage of up elevator is applied with left rudder. I know how to set the mix up on the Taranis but not how inhibit right rudder.
Many thanks
Ian
Taranis mixing
-
- Posts: 277
- Joined: Sun May 06, 2012 8:37 pm
- Country: -
- Location: Fond du Lac, WI
Re: Taranis mixing
Set up a curve that's flat (Y=0) on x>0 side and slightly sloped on the x<0 side. The slope is the amount to add to your elevator so maybe just a few percent to start.
Add a line to your elevator mix: +=IX:Rud weight (+100) Curve(CV1) "X" is your rudder input number.
Use rudder input as your source and the curve to ADD to your elevator mix. Since the curve is =0 on one side it only adds to the elevator mix when the rudder is on the one side that isn't =0.
Add a line to your elevator mix: +=IX:Rud weight (+100) Curve(CV1) "X" is your rudder input number.
Use rudder input as your source and the curve to ADD to your elevator mix. Since the curve is =0 on one side it only adds to the elevator mix when the rudder is on the one side that isn't =0.