Taranis mixing

General Help and support for the Taranis Radio.
Post Reply
baggers50
Posts: 28
Joined: Fri Dec 11, 2020 9:31 am
Country: -

Taranis mixing

Post by baggers50 »

Sure this has been covered somewhere but I cant find it. I'm flying an aerobatic model which Yaws perfectly when full right rudder is applied, when I apply full left rudder the nose drops very slightly. How do I setup the mix so that nothing happens with right rudder but a percentage of up elevator is applied with left rudder. I know how to set the mix up on the Taranis but not how inhibit right rudder.

Many thanks

Ian

pmullen503
Posts: 275
Joined: Sun May 06, 2012 8:37 pm
Country: -
Location: Fond du Lac, WI

Re: Taranis mixing

Post by pmullen503 »

Set up a curve that's flat (Y=0) on x>0 side and slightly sloped on the x<0 side. The slope is the amount to add to your elevator so maybe just a few percent to start.

Add a line to your elevator mix: +=IX:Rud weight (+100) Curve(CV1) "X" is your rudder input number.

Use rudder input as your source and the curve to ADD to your elevator mix. Since the curve is =0 on one side it only adds to the elevator mix when the rudder is on the one side that isn't =0.
baggers50
Posts: 28
Joined: Fri Dec 11, 2020 9:31 am
Country: -

Re: Taranis mixing

Post by baggers50 »

Many thanks

Post Reply

Return to “General help (FrSky Taranis radio)”