Greetings,
I have a new Taranis X9D Plus that I cannot get to bind to any receiver that I have. I have tried a TFR4SB (Quantity 2), X4R, D4R-II, and TFR6 receivers. I am somewhat new to this but i tried the auto function to have it self register (turning on the RX without binding) and manual binding (holding down the F/S button while powering the RX on).
Zip.
We have not been able to bind this radio to anything. However, we were able to bind the receivers to an older Taranis transmitter.
The X9D is using 2.3.0 firmware.
Internal radio is set to 'ACCESS' and Ch 1-16.
What am I doing wrong?
Thanks in advance.
New Taranis X9d Plus will not Bind
Re: New Taranis X9d Plus will not Bind
TFR4 and TFR6 are Futaba FASST receivers, they will not work with your radio.
X4R and D4R-II are not ACCESS receivers and need you to be in ACCST D16 mode, and the D4R-II needs a jumper to be bound to D16 mode as per manual.
X4R and D4R-II are not ACCESS receivers and need you to be in ACCST D16 mode, and the D4R-II needs a jumper to be bound to D16 mode as per manual.