SR10 Pro - Channels?

General Help and support for the Taranis Radio.
Post Reply
User avatar
mapes12
Posts: 138
Joined: Tue Jul 09, 2013 6:44 am
Country: United Kingdom
Location: Lichfield UK
Contact:

SR10 Pro - Channels?

Post by mapes12 »

Just bought one of these new Archer receivers. There are 10 PWM outputs but the manual appears to have been created by cut n pasting the channel configuration from the S8R manual. For instance, channel 9 for gain, channel 10 (Quick Mode) for flight modes. How can this be so when these channels have PWM pins? Has anyone set up one of these receivers yet?

User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: SR10 Pro - Channels?

Post by MikeB »

With the ACCESS protocol, you may map any receiver output to any channel (set in the Tx).

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
User avatar
mapes12
Posts: 138
Joined: Tue Jul 09, 2013 6:44 am
Country: United Kingdom
Location: Lichfield UK
Contact:

Re: SR10 Pro - Channels?

Post by mapes12 »

Penny has dropped.........

So, for example, channel 13 could be assigned to pin 9 and channel 14 to pin 10. Thus preserving the pins as being usable. Have I got this right?
User avatar
MikeB
9x Developer
Posts: 17990
Joined: Tue Dec 27, 2011 1:24 pm
Country: -
Location: Poole, Dorset, UK

Re: SR10 Pro - Channels?

Post by MikeB »

Yes.

Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
User avatar
mapes12
Posts: 138
Joined: Tue Jul 09, 2013 6:44 am
Country: United Kingdom
Location: Lichfield UK
Contact:

Re: SR10 Pro - Channels?

Post by mapes12 »

The attached is a how to I found on another forum demonstrating how to change the pin channel order on SR10 Pro Rx.
Attachments
SR10Pro_HowTo.pdf
(4.21 MiB) Downloaded 393 times

MichaelBerger69
Posts: 1
Joined: Mon May 17, 2021 2:48 pm
Country: -

Re: SR10 Pro - Channels?

Post by MichaelBerger69 »

mapes12 wrote: Wed Jan 27, 2021 9:25 am The attached is a how to I found on another forum demonstrating how to change the pin channel order on SR10 Pro Rx.
hello peter
thank for your pdf. ich have tested on my ethos.it a little diffrent but i can use ch 9 an 10.
but i will use ch 2 and 13 for ele. ist works stick input . but when i start the gyro then works only one servo the secound one do not turn.
who is the fail? any idears? thamks

Post Reply

Return to “General help (FrSky Taranis radio)”