HELP AGAIN s6r
HELP AGAIN s6r
Well, I flashed my s6r and my qx7 no problem. Did the bind procedure no problem. Calibrated s6r no problem. Connected everything up. Channel 3(thr), channel 5(flaps) and channel 6(landing gear) all work fine. However, channel 1(ail), channel 2(ele), and channel 4(rud) do nothing. Tried known good servos and get nothing. Other receivers work fine. This rx has never flown. Any ideas?
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: HELP AGAIN s6r
Sounds like you haven't fully done the self check procedure. The servos will move during this if done correctly.
Mike
Mike
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: HELP AGAIN s6r
You are right. Sorry it's been awhile
Re: HELP AGAIN s6r
Before I do the self check procedure I will need to run FrSky SxR.lua correct?
Re: HELP AGAIN s6r
Only if you need to configure parameters in there...