Two RSSI Values

[seabee]

Is there any way to change the RSSI ID of a receiver so that if you have two receivers bound to a model (D8 & D16) you can stop the RSSI values being merged and see both? (I do want both.)

[Kilrah]

Explain your setup a bit better, because you can't bind 2 receivers in different modes with just the internal module.

[seabee]

Explain your setup a bit better, because you can't bind 2 receivers in different modes with just the internal module.

The set up is 2013 Taranis X9D with an external XJT module in D8 mode communicating with a D8R-XP, this is flying the plane with a FBVS-01 monitoring the flight battery. The Internal module in LBT D16 mode is bound to a R-XSR which does nothing other than report S-PORT sensor data. The two are not necessarily in the same place at the same time which is why I would like both RSSI values or at least not have them combined.

[Kilrah]

You cannot get telemetry data from 2 modules on an X9D. Both modules are connected to the same telemetry line and will continually corrupt each other's data, only one may provide telemetry at a time.
XJT needs to be set to the "disable telemetry" mode if it's to be used simulataneously with the internal module.

[seabee]

You cannot get telemetry data from 2 modules on an X9D. Both modules are connected to the same telemetry line and will continually corrupt each other's data, only one may provide telemetry at a time.
XJT needs to be set to the "disable telemetry" mode if it's to be used simulataneously with the internal module.

OK - Thanks