rpm display counts in reverse
rpm display counts in reverse
i am using a radiomastertx16s transmitter, DSMX receiver (AR8010t) and a brushless motor rpm sensor (SPMA9558) in a 600 size helicopter. Everything works good (binds ok flies ok) except for the rpm display count. It counts down as the actual rpm increases. Is the problem with the receiver, the sensor, the transmitter, or the opentx software? Where do I start? Is this a fixable problem? Help!!
Re: rpm display counts in reverse
You should try the multiprotocol module thread.
https://www.rcgroups.com/forums/showthr ... p=46626987
https://www.rcgroups.com/forums/showthr ... p=46626987
Re: rpm display counts in reverse
Thanks I will give it a try. Is it possible for the receiver to bind but not right freq air to surface?
Re: rpm display counts in reverse
No. Probably an error in handling of that particular sensor.
Re: rpm display counts in reverse
None of the above things corrected the problem. The rpm reading works accurately when binding to the dx6e transmitter however when binding to the radiomaster tx16s everything works accurately EXCEPT the rpm reading. To me it indicates a glitch in the Multiprotocol Module hardware or software. Is there someone that can prove me right or wrong.
Re: rpm display counts in reverse
I told you to ask there since that's where the people who use/know such combinations might be able to answer.