M9 Hall Sensors Dead Space Pt.2

Cant get your radio to work? General Hardware issues?
Post Reply
Brycito
Posts: 1
Joined: Fri Dec 11, 2020 11:23 pm
Country: -

M9 Hall Sensors Dead Space Pt.2

Post by Brycito »

Hey Guys, I really can’t find anything about this anywhere. I have a Taranis x9D 2019 and recently installed m9 hall sensors in it. After installing I went to calibrate and everything went perfect except for when I noticed that the roll isn’t going all the way to the side (100) and only goes to around 90. To get it from that 90-100 I have to push into the gimbal while pushing the roll over and then it will register it as all the way pushed over. Throttle, Yaw, and Pitch are all fantastic. All responses are greatly appreciated, and thanks so much!

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: M9 Hall Sensors Dead Space Pt.2

Post by Kilrah »

Make sure not to force when calibrating if you don't want to also have to force while using.
Post Reply

Return to “Hardware”