Hi
I still hav a small surface mount resistor in place as per RCModelreviews lion 7.4 volt mod. I am now on er9x and found a life 3s battery to be better. Can any damege occur if I leave the voltage sensor fooling resistor in place until I open the radio again?
Sent from my LT18i using Tapatalk 2
RCModelreviews Battery mod removal
RCModelreviews Battery mod removal
Er9X Flashed
Speaker Mod Done
Haptic Feedback Mod Done
Telemetry Mod Done with FRSky TTL Lite
Voice Mod Done with Emartee Board
HK Backlight Done
FRSky Telemetry DIY Module Installed
----All these mods removed and installed Sky 3.0 board with DJT Module.
Speaker Mod Done
Haptic Feedback Mod Done
Telemetry Mod Done with FRSky TTL Lite
Voice Mod Done with Emartee Board
HK Backlight Done
FRSky Telemetry DIY Module Installed
----All these mods removed and installed Sky 3.0 board with DJT Module.
- Crashj007
- Posts: 133
- Joined: Tue Jan 31, 2012 11:44 pm
- Country: -
- Location: Raleigh, NC, USA
- Contact:
Re: RCModelreviews Battery mod removal
I think you just need to recalibrate the voltage reading and the alarm setting for now since you have er9x.
--
FS-TH9X 2.4GHz 9CH from Nitroplanes
Smartieparts board & backlight
Stock Flysky RF and mainboard
er9x FW V 744
FS-TH9X 2.4GHz 9CH from Nitroplanes
Smartieparts board & backlight
Stock Flysky RF and mainboard
er9x FW V 744