Hello,
I have set up an openXsensor with 2x GY63. The 2nd sensor contains a connection for a TEK nozzle. My target is to use sensor one for altitude, sensor 2 with TEK nozzle for vertical speed.
When I configure the sensor to use both MS5611, I have regular outliers in the values of Vspd and Vspd2 (both sensor data are comparable
If I configure the sensor so that only one MS5611 is used, I have the normal noise without outliers.
left side: configured with both MS5611
right side: configured with one MS5611
any ideas what this could be?
Test was done outside of my house with very little wind (<1m/s), no TEK nozzle connected, no direct sunlight
Attached the 2 extracted log files and my openXsensor file
Best regards,
Christoph
Strange outliers in Vspeed with 2x MS5611
Moderator: rainer
Strange outliers in Vspeed with 2x MS5611
- Attachments
-
- openXsensor_2xGY63_16MHz.zip
- (339.88 KiB) Downloaded 169 times
-
- 2_GY63_16MHz.csv
- (385.71 KiB) Downloaded 159 times
-
- 1xGY63_16MHz.csv
- (289.34 KiB) Downloaded 163 times
-
- 2xGY63_vs_1xGY63.PNG
- (315.2 KiB) Not downloaded yet