openxsensor jeti dual temp and rpm

Development & General Chat for the superb openxvario project.

Moderator: rainer

Post Reply
uragano47812
Posts: 9
Joined: Fri Aug 25, 2017 11:47 am
Country: -

openxsensor jeti dual temp and rpm

Post by uragano47812 »

Hello i have a Pro mini 3.3V. I'm using 2x NTC sensors from Frsky ( the ones sold with their S.port RPM Temp sensor). I'm using 2x 100k ohm resistor from VCC--100k--A0 and one VCC--100k--A1. The sensors are connected to GND and A0 and A1 respectively. D8 i used to read RPM and i use also a 10K resistor from CDI signal (rcexl) of a gas engine to D8 the other wire from CDI i connected to GND.

I setup Baisc and advanced config as attached. I can read only one temperature (VOLt_1 -- A0) and i don't know where to change to show all 2 values. The temp showed on A0 is correct as ambient temperature.

Also where can i change the name of the value in the display of the radio? I want to see TempDX and TempSX if possible. And avoid to see not used one like RelAlt.

Thanks
Adriano
Attachments
oXs_config_advanced.h
(16.85 KiB) Downloaded 148 times
oXs_config_basic.h
(11.73 KiB) Downloaded 153 times

uragano47812
Posts: 9
Joined: Fri Aug 25, 2017 11:47 am
Country: -

Re: openxsensor jeti dual temp and rpm

Post by uragano47812 »

I looked at description file and oXs_out_jeti.h It seems that if i want to use 2 NTC probe for dual temp i need to use 2 separate Arduino boards.
I'm right? Dual temp are only for some protocols like Frsky or Hott?

Thanks
Post Reply

Return to “OpenXVario - an open source vario supported by the open source firmwares!!”